SonarPhone SP100, Руководство пользователя

Страница: 31 / 38

3.
With transducer in place, mark the two slot locations of the transducer mounting
brackets. Drill in center of slot outline using a 1/8” (.125") drill.
4.
Fasten the transducer to the transom using the #8 x 1/2” screws, nuts and washer
plates.
5.
Before final tightening the 2 screws holding the brackets to the transducer, tip
the rear edge down approximately 1/8” as shown.
6.
Tighten all screws.
CAUTION . Do not use any thread locking compound on the screws. Most
products such as Loctite® contain chemicals that attack and weaken
plastics.
Install the SP200 In-Hull
Finding the best location for the transducer before you mount it
is critical. Choose a flat smooth spot near the center of the bilge
and near the back of the boat. It is a good idea to make a "test
run" before you permanently install the transducer to make sure