SonarPhone SP100, Руководство пользователя

Страница: 25 / 38

1.
Dampen a paper towel with cool water.
2.
Bunch it up and place it against the pins on the underside of SP100.
3.
Watch as the light turns on and then begins to flicker.
4.
Connect to the SP100 with your SonarPhone App. Refer to the WiFi connection
instructions if needed. Make sure the GAIN is at least 70%. (You can remove the
wet towel)
5.
Hold the SP100 about 1 meter above a hard flat floor (not carpet).
6.
Point the flat part of the bottom of the SP100 at the floor and watch for the echo
to appear on your SonarPhone chart. The more perfect your aim at the floor, the
stronger the echo will appear. Increase the gain level if you cannot find a floor
echo.
7.
The SP100 will time-out and turn itself off 30 seconds after the pins have dried.
IMPORTANT : The SP100's "Wet Switch" pins must be rinsed
with fresh water after exposure to salt water to prevent
corrosion.
IMPORTANT : Do not place the SP100 in a wet area or on a
metal surface when not in use as this will activate the
SP100, drain it's battery and help shorten its usable life.
Store the SP100 in a dry area.
Resetting Your SP100 To Factory Default
A. The T-pod must be OFF and FULLY CHARGED before
resetting.
B. Using the shorter (reset) lead on power charging cable
you need to connect to power then connected to your SP100
for at least 10 seconds.