Sonardyne 6G ROVNAV 6, Быстрый старт

Страница: 15 / 16

STEP 14
RETRIEVAL & STORAGE
When the ROVNav 6 is not being used, it should be placed in storage to make sure it remains fully
operational.
Electric shock hazard risk if the Remote Transducer output connector contacts are
touched whilst the transducer cable is disconnected, the unit is powered and if
instructed to transmit. Never touch the connector contacts whilst the power is on.
WARNING
6 Disconnect all electrical connections.
7 Check the Pressure Relief Vent Valve is flush with the Sensor End-Cap.
8 Release the ROVNav 6 from its secure location on the ROV.
9 Release the Remote Transducer from its secure location on the ROV.
10 Remove the connecting cables.
11 Pack all components into the transportation container and store in a dry secure area.
1 Rinse the ROVNav 6, Remote Transducer and connecting cables with clean fresh water.
2 Dry the ROVNav 6, Remote Transducer and connecting cables with a clean lint free cloth.
3 For extended periods of storage it is recommended the battery is electronically disconnected.
4 Connect to the 6G Terminal Lite software as detailed in
Step 5
.
5 In the 6G Setup tab navigate to the Battery section. Click Disconnect to electrically
disconnect the battery.
The ROVNav 6 weighs 13 kg, Manual Handling Equipment (MHE) must be used to
move the transceiver. If MHE is not available, then a manual handling assessment
must be carried out prior to carrying out manual lifting / handling. Make sure
Personal Protective Equipment such as protective footwear and gloves are worn
before lifting this equipment.
WARNING
Battery reconnection will require an external power supply to initially power the
unit.
For further information on the ROVNav 6 go to:
http://www.sonardyne.com/products/all-products/instruments/730-rovnav-
6.html.
2
NOTE