10
IN/OUT SETTINGS TAB
Input Setup
Output Source
Input Name
Source 1
Source 2
Mode Source 2
Off
Mix
Mute
Input Trim dB
Output Setup
Output Name
Stereo / Mono
DSP Preset
Output Group
Bridge Mode
The IN/OUT Settings tab is used to assign your MKII’s input
and output specifications.
This is a user entered field with a maximum of 15 characters.
Use these fields to describe the type of input connected.
This is the primary source you will direct to the speakers.
Any of the inputs available on the amplifier can be selected.
When channels are in the same Output Group, the inputs
will all change in unison. Left inputs default to left outputs
and right inputs to right outputs.
This is a secondary source that, based on the Mode Source
2 setting described below, will either override or mix with
Source 1. This input could be used for a doorbell or paging
for example.
When set to OFF, the second source has no effect on the
operation of the channel.
When set to MIX, Source 1 and Source 2 will be blended
together when a signal is present on Source 2.
When set to MUTE, Source 1 will be muted while Source 2
is active.
This pull down menu allows for input levels to be adjusted
+/-6dB. This gives you the ability to level out all your inputs
so when you switch from input to input the levels will be
equal. This can eliminate any harsh transitions between
sources with different output voltages. Select the pull down
menu in each channel to adjust the level trim between plus
or minus 6dB in increments of .5dB.
This is a user entered field with a maximum of 15 characters.
Use these fields to describe the location of the speakers.
Allows each channel to be set for Stereo or Mono operation.
When Mono is selected the Left and Right of the input
selected will be combined to create Mono.
Apply any of the available Sonance DSP presets to each
channel of the amplifier independently. You can apply any open
preset & then make modifications on the EQ Settings page.
The DSP 8-130 has eight Output Group options A-H.
When using IP or IR to control the amplifier, commands
are sent to an output group and not to a specific channel.
When more power is required, two channels can be bridged.
Follow the instructions on page 5 for connecting the wires
then select Bridge ON.
Sleep Mode
Info
Off
After 15 Minutes
After 3 Hours
When set in the OFF mode the channel will be on at all times.
Use the OFF setting for audio signals like a doorbell or paging
where audio must be reproduced immediately at any time.
Sleep mode allows you to select how long the amplifier will
stay active after the trigger method subsides.
The orange blocks are installer entered data. Each field has a
maximum of 15 characters.
When an audio signal has not been present on a channel
for 15 minutes, the channel will go to sleep. From the sleep
state the channel will take approximately 2-3 seconds
to reproduce audio again. This mode is similar to legacy
Sonamp Auto-On operation.
When an audio signal has not been present on a channel for
3 hours, the channel will go to sleep. From the sleep state the
channel will take approximately 2-3 seconds to reproduce audio
again. This mode works well for home theater installations.
