8
Output Settings / Output Volume
Identify Amplifier
Output Name
ID Amp Mode
Info
Output Volume
This is a user entered field with a maximum of 15 characters.
Use these fields to describe the room or area the channel
will be powering.
When the power switch is turned ON, the power button on
the front of the amplifier will flash to indicate which amplifier
you are programming. This will make the amplifier easy to
identify in a multiple amplifier installation.
This is a user entered field with a maximum of 15
characters. Use this area to name your MKII.
The basic setup is complete!
If you are using a control system to adjust the volume you
can skip these two steps.
1. Set the Output Volume for each channel pair.
2. Set the Turn On Volume the same as the Output Volume.
a. It’s important to set the Turn On Volume the same in
case the amplifier power is shut off accidentally.
b. Front panel level controls overwrite these two settings.
NOTE: LEFT AND RIGHT CHANNELS ARE LINKED. OUTPUT
VOLUME IS LINKED TO TURN ON VOLUME IN BASIC SETUP.
ADVANCED SETUP PAGE
GENERAL SETTINGS TAB
Advanced Setup
IP SETUP
DHCP On/Off
To start click on the Advanced Setup
button from your MKII’s homepage.
This page in SONARC allows you to make advanced changes
to the your amplifiers settings and configuration.
The Advanced Setup automatically starts out on the General
Settings tab. This tab is used to set up your MKII with a
network connection, triggering and other basic information.
Input Settings / Source Select
Input Source
Input Name
This is a user entered field with a maximum of 15 characters.
Use these fields to describe the type of input connected.
This pull down menu allows you to select which Input you
would like to assign to the channel.
DHCP ON/OFF is the first option in IP SETUP. All Sonance DSP
series amplifiers ship with DHCP (Dynamic Host Connection
Protocol) ON. In most installations DHCP should be left ON
except when you are using a control system for IP control.
If you are controlling the DSP series amplifier using IP, then
we suggest you turn DHCP OFF and use a static IP address.
