Copyright © 2010 Somfy SAS. All rights reserved.
Sunea screen io
9
EN
TIPS AND RECOMMENDATIONS
8.
Questions on the Sunea screen io?
8.1.
Observations
Possible causes
Solutions
The awning does
not operate.
The wiring is incorrect.
Check the wiring and modify it if necessary.
The motor is hot.
Wait until the motor cools down.
An incorrect cable has been used.
Check the cable and ensure it has 3 leads
The io control point battery is low.
Check whether the battery is weak and
replace it if necessary.
The control point is not compatible.
Check for compatibility and replace the
control point if necessary.
The io control point used has not been
programmed into the motor.
Use a programmed control point or program
this control point.
The awning stops
too soon.
The crown is incorrectly positioned.
Fit the crown correctly.
The end limits have been incorrectly
set.
Readjust the end limits.
Replacing a lost or broken Somfy io control point
8.2.
Refer to the corresponding guide.
Restoring the original configuration
8.3.
This reset deletes all control points, all the sensors and all the end limit settings, and resets the
motor’s direction of rotation and favourite position (my). However, the advanced functions («Back
release», «Closing force») are maintained.
Only switch off the power for the motor to be reset.
1) Put the awning in the middle position (if possible).
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on: the awning moves for
several seconds.
If the awning is at the upper or lower end limit, it will
make a brief movement.
6) Hold down the PROG button: the awning will make a first
movement followed by a second a few instants later. The
motor is configured with the factory settings.
Repeat the procedures from the
-
Commissioning
»
section
2 sec.
2 sec.
15 sec.
5 sec.
1
6
5
3
2
4
OFF
OFF
ON
ON
my
Содержание Sunea io
Страница 43: ......
