23
English
Settings
5
22
Electrical connections
4
Turn the motors' lock knob into the locked
position .
■
Steps:
❏
Symbols used.
❏
Programming the remote control memory.
❏
Programming the leaves' travel.
❏
Setting the automatic mode.
❏
Switching from automatic mode to sequential mode.
❏
Programming the remote control memory.
Before starting to configure your installation, check that the ON/OFF and PROG LEDs are on,
and that DANGER
is not.
Complete the following steps:
●
Operating the remote controls:
Your SGA can work with one or more remote controls.
The operations described below should be repeated once for each remote control you wish
to program.
Your SGA has two operating modes:
Complete opening only
Both leaves systematically open com-
pletely with either a short or long press
on the remote control.
Pedestrian or complete opening
A single leaf opens to allow pedestrians
access, with a short press on the
remote control.
The two leaves open completely with a
long press on the remote control.
❏
Symbols used.
●
Connect the earth wire:
●
Connect the phase and the neutral:
❏
Connecting the mains power cord.
❏
Locking the arms.
Close both leaves, and push the arms to latch them.
Short press
less than 0.5 seconds
Long press
longer than 0.5 seconds
LED blinking
LED on
Never cross the
antenna's wire.
Blue wire
Neutral
Red/brown/black wire
Phase
Green/yellow wire
Earth
❏
Connecting the antenna.
For best performance, the antenna must
be positioned properly.
It is absolutely essential to match the colours when connecting the cables.
SGA6000 gb.qxd 12/02/08 17:54 Page 22
