44
EN
Copyright © 2014 - 2016 Somfy SAS. All rights reserved.
Non contractual images.
Observations
Possible causes
Solutions
The rotation direction of
the drive does not self-
adjust automatically.
This is a small roller shutter about
0.6
m x 0.7
m (about 0.5
m
²
).
Position the roller shutter at down position and
raise it by holding it slightly with your hand (without
stopping it) for 5
seconds. Place it back in down
position. On the next movement, the roller shutter
will have found its direction of rotation.
2.4.2. Deactivating the Smart Protect function
The Smart Protect function can be deactivated with the Somfy io-homecontrol
®
local control point.
The S&SO-RS100
io then works with standard obstacle detection while guaranteeing the protection
of the roller shutter.
Once deactivated, the Smart Protect function cannot
be reactivated with the Somfy io-homecontrol
®
local
control point.
1)
Position the roller shutter at its half-way position.
2)
Cut the power supply for 2 seconds.
3)
Switch the power supply back on.
4)
Simultaneously
press
my
and
V,
for
≈
5 s
,
until
there
is back and forth movement
by the roller shutter.
→
The Smart Protect function is deactivated.
2.4.3. Replacing a lost or broken Somfy io-homecontrol
®
control point
Apply the double cutout only for the end-product to
be reset.
This reset deletes all io-homecontrol
®
local control
points; however the sensors, end limit settings and
favourite position are retained.
1)
Position the roller shutter at its half-way position.
2)
Cut the power supply for 2 seconds.
3)
Switch the power supply back on for 5 to 15 seconds.
4)
Cut the power supply for 2 seconds.
5)
Switch the power supply back on: the roller shutter
moves for a few seconds. (If the end-product is in the
upper or lower end limit position it will move back and
forth briefly.)
6)
Press the PROG button on the new io control point until
the roller shutter moves back and forth: the new control
point is programmed and all the other io control points
are deleted.
2.4.4. Deleting the end limit settings: return to default automatic mode
1)
Position the roller shutter at its half-way position.
2)
Simultaneously
press
Λ
and
V,
for
≈
5 s
,
until there
is back and forth movement
by the roller shutter.
3)
Simultaneously
press
Λ
,
my
and
V,
for
≈
2 s
,
until
there is back and forth movement
by the roller shutter:
→
The end limit settings are deleted.
The control points, the sensors and the favourite position
(my) are still programmed.
-
Resume the set-up operation (see
Set-up
section).
2 s
1)
3)
2)
4)
OFF
ON
5
S
6)
my
2 s
2 s
15 s
5 s
1)
5)
3)
2)
4)
OFF
OFF
ON
ON
1
5
S
2
S
1)
2)
3)
