Copyright © 2009 Somfy SAS. All rights reserved.
Oximo WireFree™ Battery
17
EN
1. Introduction
17
2. Safety
17
2.1 Safety and responsibility
17
2.2 Specific safety advice
17
3. Installation
17
3.1 Preparation
17
3.2 Installing the battery
18
4. Wiring
19
5. Commissioning
20
5.1 First charging
20
5.2 Radio activation/deactivation of motor 20
6. Use and operating mode
20
6.1 Battery charging
20
6.2 Excessive discharge protection for the
battery 21
6.3 Maintenance
21
7. Tips and recommendations
22
7.1 Problem with the Oximo
WireFree™ Battery?
22
7.2 Replacing a lost or broken RTS control
point or RTS sensor
22
7.3 Restoring the original configuration 23
7.4 Battery recharging
23
7.5 Battery replacement
23
8. Technical data
24
Contents
1. Introduction
The Oximo WireFree™ Battery is an extended voltage range battery used for storing the electrical
energy supplied by the Oximo WireFree™ Solar Panel and for powering the Oximo 40 DC RTS low
consumption motor.
These 3 components form the Oximo 40 WireFree™ RTS roller shutters motor kit.
The Oximo WireFree™ Battery is also referred to as "the battery" in this guide.
2. Safety
2.1 Safety and responsibility
Before installing and using the product, please read the installation guide carefully.
This Somfy product must be installed by a professional motor installer, for whom these instructions
are intended.
Moreover, the installer must comply with current standards and legislation in the country in which the
product is being installed, and inform his customers of the operating and maintenance conditions for
the product.
Any usage outside of applications defined by Somfy constitutes non-compliance, and is therefore not
covered by the guarantee. In this event, as for all usage not consistent with the instructions given
herein, Somfy accepts no responsibility for harm or damage.
Never begin installing without first checking the compatibility of this product with the associated equi-
pment and accessories.
2.2 Specific safety advice
Do not open or pierce the battery.
1)
Do not dispose of the battery by burning. Risk of explosion!
2)
Never throw out the battery with domestic waste.
3)
Please take the battery
to a collection point or an approved centre to ensure that it is recycled.
Never submerge the battery!
4)
3. Installation
3.1 Preparation
3.1.1 Battery location
The three components that make up the Oximo 40 WireFree™ RTS kit must be installed on the same
side as the roller shutter.
Oximo_WireFree_battery.indb 17
25/02/2009 12:44:47
