Copyright © 2009 Somfy SAS. All rights reserved.
Oximo WireFree™ Battery
22
EN
7. Tips and recommendations
7.1 Problem with the Oximo WireFree™ Battery?
Problems
Possible causes
Solutions
The roller shutter is not operational.
The wiring is incorrect.
Check the wiring and modify it if
necessary.
The motor is deactivated.
Activate the motor using the battery's
PROG button.
The battery is weak.
Wait for the solar panel(s) to recharge
the battery, or have the battery
recharged.
One of the components (motor, solar
panel, control point, ...) is not working.
See the corresponding guides.
The roller shutter stops briefly
before raising, when the Up button
is pressed.
The battery is weak.
Wait for the solar panel(s) to recharge
the battery, or have the battery
recharged.
The roller shutter performs two brief
movements in the same direction,
when the Down button or STOP/my
button is pressed.
The battery is low
The battery is recharged several
times in a year using the external
battery charger.
One solar panel is not sufficient to
charge the battery.
Check the number of solar panels
required according to the configura-
tion, and add a solar panel if need be,
see Oximo WireFree™ Solar Panel
guide.
The solar panel(s) is (are) faulty or
damaged.
Replace the solar panel(s), see Oximo
WireFree™ Solar Panel guide.
The battery has reached the end of its
service life.
Replace the battery.
7.2 Replacing a lost or broken RTS control
point or RTS sensor
Caution! This procedure deletes all the previously program-
med RTS control points and all the RTS sensors. However,
the programmed favourite position and settings made are
retained.
1) Press and hold the battery PROG button for over 7
seconds (but under 12 seconds).
The roller shutter will make an up and down move-
ment, and repeat it a few moments later.
All the RTS control points and sensors are erased.
To program a first RTS control point:
-
Press the battery PROG button again until the roller shut-
2)
ter makes an up and down movement:
The motor is in programming mode.
Press the RTS control point PROG button until the roller
3)
shutter makes an up and down movement:
The RTS control point is programmed into the
motor.
To add RTS control points or RTS sensors:
-
See the Oximo 40 WireFree™ RTS guide.
1
PROG.
3
2
7 sec. <
PROG.
< 12 sec.
PROG.
Oximo_WireFree_battery.indb 22
25/02/2009 12:45:10