http://www.remotecontrol-express.com
SOMFY Keytis NS2RTS
Programming of your new remote control
Receiver type 1 (fig.1):
1.
Open the casing of your receiver. It is located next to your motor.
2.
On the receiver circuit board, press the programming button «
light L1 on the receiver illuminates.
3.
Press a button on your new remote control. Let it go. The LED light o
then turns off (4).
4.
Wait 10 seconds.
5.
Your new remote control is programmed.
Receiver type Axroll (fig.2) :
1.
Open the casing of your receiver.
2.
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
digital screen.
3.
After a second, the position 0.0 appears on the screen which corresp
function of your door.
4.
Simultaneously press the button you wish to program on your new remote control and the +
button in your receiver for three seconds.
go.
5.
Wait 10 seconds.
6.
Your new remote control is programmed.
Programming Manual
express.com
-
TEL :
+44 (0) 207 399 7782 - FAX :
+44 (0) 207 927 3151
SOMFY Keytis NS2RTS - Keytis NS4RTS
ming of your new remote control:
Open the casing of your receiver. It is located next to your motor.
On the receiver circuit board, press the programming button « Prog 1 » (fig 1) until the LED
the receiver illuminates.
your new remote control. Let it go. The LED light on the receiver blinks and
Your new remote control is programmed.
Open the casing of your receiver. It is located next to your motor.
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
a second, the position 0.0 appears on the screen which corresponds to the open/close
Simultaneously press the button you wish to program on your new remote control and the +
button in your receiver for three seconds. Two dashes appear on the screen. Let the buttons
remote control is programmed.
+44 (0) 207 927 3151
Keytis NS4RTS
fig 2
(fig 1) until the LED
the receiver blinks and
On the receiver circuit board, press on the arrows until you get to the position P.8 on the
onds to the open/close
Simultaneously press the button you wish to program on your new remote control and the +
Two dashes appear on the screen. Let the buttons
