4.2.5 OFF mode
In this operating mode, only manual commands are carried out.
– Switching to OFF mode
Press the “
+
“ on the
button briefly
➜
display shows OFF.
– Switching from OFF mode to automatic mode
Press the “
-
“ on the
button briefly
➜
display shows the time.
+
-
+
-
We reserve the right to make changes due to technical improvements.
Chronis RTS/RTS L
4
If you do not wish these cut-off times to affect the opening or closing, and you want the roller shutters to be operated at sunrise and sunset and
only with the corresponding differential times, you can set the cut-off time to OFF. To switch the cut-off time to “OFF”, the cut-off time must be
set to between 23:59 and 0:00 using the
button.
+
-
Entering a differential time
1. Press and maintain
until the display shows (COS 1) (if not already set)
2. Press
briefly
➜
time flashes and next switching command is displayed
3. Press
briefly
➜
UP differential time flashes
4. Change UP differential time using
button
5. Press
briefly
➜
DOWN differential time flashes
6. Change DOWN differential time using
button
7. Press
briefly (differential times are stored)
➜
time is displayed
There is no default differential time !
+
-
+
-
Press and maintain
and
buttons during 10 seconds to reset the settings.
Entering cut-off times
1. Press and maintain
until the display shows (COS 1) (if not already set)
2. Press
briefly
➜
time flashes and the next switching command is displayed
3. Press
twice quickly
➜
UP cut-off time flashes
4. Change UP cut-off time using
button
5. Press
twice quickly
➜
DOWN cut-off time flashes
6. Change DOWN cut-off time using
button
7. Press
briefly (cut-off times are saved)
➜
time is displayed
The factory default setting is 6:00 for UP cut-off time and OFF for DOWN cut-off time !
+
-
+
-
4.2.4 Cosmic 2 (COS 2)
Cosmic 2 always opens the roller shutters at the times set individually in the weekly programme and closes them at the ti-
mes set for Cosmic 1.
The cut-off and differential times set in Cosmic 1 are observed.
No changes can be made in Cosmic 2.
5
Manual operation
CHRONIS RTS is initially configured to control a roller shutter but it is possible to configure it to control a venetian blind (orientation of the slats).
vbEU : Venetian blind “european mode” for Centralis indoor RTS VB EU mode / Orienta receiver EU mode.
vbUS : Venetian blind “US mode” for Centralis indoor RTS VB US mode / Orienta receiver US mode / RTS 25 DC / Power 2.5 RTS). This function must be
choosen to drive ALTUS; OREA; OXIMO light sensor controlled into IP position.
1. Press and maintain
+
+
until the display shows
2. Press
three times until the display shows
3. Press
to select the operating mode : roller shutter
; venetian blind EU
; venetian blind US
4. Press
briefly to store the choosen mode.
4.2
Setting operation mode
4.3
Reset operation
4.2
Setting operation mode
5.1
Setting the operation mode (Stn; vbEU; vbUS)
