®
• Raise the blind at its
UP
limit
with the
key.
1
• Push simultaneously on the
and
keys until the LED lights
on in “green”.
The blind begins to move down.
• Stop the blind at the interme-
diate position you wish with
the
key
.
If necessary, adjust this position
with the
keys.
• Push the
key more than 2
sec.
➭
The LED lights off,
the CEN-
TRALIS Uno IB VB has memorized
the intermediate position.
2
3
• Push simultaneously on the
and
keys until the LED lights
on in “green”.
The blind momentarily moves up.
• Adjust the right tilt angle with
the
keys
.
• Push the
key more than 2
sec.
➭
The LED lights off,
the CEN-
TRALIS Uno IB VB has memorized
the tilt angle.
4
during
2 seconds
after
3 seconds
STOP
IP
5
6
7
after
3 seconds
during
2 seconds
With the
CENTRALIS uno IB VB
, it is possible to program an intermediate position (IP) and an automatic opening of the slats
at this position.
Principle : the
CENTRALIS uno IB VB
records the timing for the venetian blind to go from the starting position to the interme-
diate position you wish to program.
Threfore, the intermediate position must be set from the UP limit of the venetian blind in order to always get the same adjust-
ment.
Non-binding document.
Products and references in this document are subject to change without prior notice.
Please consult SOMFY
be
fore using such references.
© SOMFY 09/00
To reach the right intermediate position preset, the blind must be at its UP limit.
• Press briefly the
key.
➭
The blind moves down, stops at the intermediate position and the slats tilts at the preset
angle.
Be careful :
•
if you reach the IP after an UP command but not from the UP limit, the blind will not
stop at the right preset intermediate position, but the slats will tilt.
•
if you reach the IP after a DOWN command (ie : blind at the DOWN limit), you will
only get the tilting of the slats.
during
8 seconds
Reach the intermediate position, then press
and hold the STOP for more than 8 secs. until
the led lights on in “red”.
➭
The intermediate position and the tilt set-
ting are deleted.
Note : The intermediate position can only be recorded and reached by the local push buttons.
Intermediate position / automatic slats tilting
Setting of the intermediate position
Setting of the automatic opening of the slats
Using
Delete the intermediate position
IP
adjust the
angle
UP limit
UP limit
orientation
Green
Green
Red