5
..
EN
SSO
-
O3
-
SPA01
-
User Manual (EN)
1.7
-
Operation:
1.7.1
-
With the SPA filled to the proper level, run the SPA Controller through several
cycles.
1.7.2
-
Check for and correct any leaks in the ozone tubing.
1.7.3
-
Check that the Ozone Generator is working properly. Note that bubbles are being
placed into the SPA via heater return and you will notice a faint scent that resembles a
rain storm.
WARNING:
Do not breathe ozone directly. If there is any leakage of ozone in the system, turn it off
immediately and leave the space and only return after 30 minutes (so that all the ozone in
the air is completely dissipated). According to OSHA standards, you should not be exposed
for more than 0.1 ppm for periods of 8 hours / day.
Image 3
-
Electrical Diagram
WARNING:
The Ozone Generator works at high voltage and should only be opened by Solution Ozone®
Technicians. Before carrying out any work on the Pool Circulation System, make sure that
the electrical supply to the Ozone Generator is turned off.
Copyright @ 2020 Ozone Solution. All rights reserved. This document accompanies the O
3
System for SPAs. This document is subject to review.
Merely illustrative images.
Ver2/01
-
Ver.02