Solter aerotig 4320 DC, Инструкция по эксплуатации

Страница: 32 / 55

The machines are prepared to work with an electric generator. However, these generators must meet certain require-
ments. It is recommended to use three-phase generators with a constant power of at least 25KVA. If the generator
does not have enough power or the output voltage is outside the operating limits of the machine, the stability of the
welding arc and, therefore, the quality of the weld joint could be affected. In the worst case, it can even cause da-
mage to the machine.
Do not use more than one welding machine with the same generator at the same time. Sudden changes in charge
level may affect the stability of the welding arc.
5 - Start the machine by turning the switch placed on the back of the power unit. During the startup sequence, the
machine performs an internal test. If a fault is detected, the associated code will appear on the front panel display.
Always start or stop the machine using the rear switch, NOT by plugging or unplugging it from the mains.
FRONT PANEL LAYOUT
ATTENTION
Do not stop the machine while welding .
1- Display
2- Amps visualization
3- Frequency
4- Voltaje or mm visualization
5- Percentage (%)
6- Time (0,1s)
7- Overtemperature
8- Common problems
9- Pre gas time
10- Starting current / time
11- Slope up time
12- Hot Start current in MMA
13- Nominal current
14- I force current in MMA
- I1 TIG pulsation current
15- I2 TIG pulsation current
16- Slope down time
17- Amps / time of stop
18- Menu Acces
19- Post-gas Time
20- I1 TIG pulsation current time
21- I2 TIG pulsation current time
22- MMA welding selector
23- MMA Mode
24- DC Negative polarity
25- DC Positive Polarity
26- AC Polarity
27- Mix Polarity
28- TIG Mode
29- TIG welding selector
30- TIG pulsation current selector
31- TIG constant current mode
32- Low frequency pulse mode
in TIG
33- High frequency pulse mode
in TIG
34- Main Selector
35- HF ignition in TIG mode
36- 4T operation mode (in TIG mode)
37- 2T operation mode (in TIG mode)
38- Operation mode selector in TIG
39- AC mode selector
40- AC AUTO configuration
41- AC Frequency
42- AC balance
43- AC Offset
44- DC current time in MIX
45- AC current time in MIX
46- Electrode diameter
47- Program visualitzation
48- Load a program
49- Save a program
SOLTER
SOLDADURA S.L. AEROTIG AC/DC 31