Solter aeroprocess 4200 DV, Инструкция по эксплуатации

Страница: 47 / 59

P.27 - Not available in this model.
P.28 7
Arc-force sensitivity for coated electrodes.
It allows adjustment of sensitivity to activate the arc-force mode. A high value delays
the activation of this feature. Lower values improve the transfer of material for alumi-
nium or stainless steel-coated electrodes.
P.29 65 Amperage preheating during TIG contact ignition.
P.30 - Not available in this model.
P.31 - Not available in this model.
P.32 - Not available in this model.
P.33 - Not available in this model.
P.34 - Not available in this model.
P.35 3 Coolant circulation time at the end of a weld, in 10-second intervals.
P.36 Nor
Mode of operation of the cooling unit.
It is recommended to have the automatic mode selected at all times.
Nor - Automatic mode (recommended).
For - Forced mode. This can be used for a short period of less than 2 minutes to faci-
litate the task of priming the coolant circuit.
dis –Disabled mode. Select this mode if an uncooled torch is going to be used. Re-
member to enable the automatic mode again when finish. DO NOT disable the cooler
if you are using a cooled torch as this could damage the torch.
P.37 - Not available in this model.
P.38 - Not available in this model.
P.39 - Not available in this model.
P.40 - Not available in this model.
P.41 - Not available in this model.
P.42 - Not available in this model.
P.43
-
Not available in this model.
P.44
-
Not available in this model.
P.45
-
Not available in this model.
P.46 1
1 is recommended to manage bead penetration depending on the energy of the arc,
or 0 to manage penetration depending on the amperage.
P.47 0
If enabled, it allows the penetration control a greater arc height variation. It is recom-
mended to keep it disabled to minimize welding defects.
P.48 - Not available in this model.
P.49 - Not available in this model.
P.50 - Not available in this model.
P.51 - Not available in this model.
P.52 - Not available in this model.
P.53 - Not available in this model.
P.54 - Not available in this model.
P.55 - Not available in this model.
P.56 - Not available in this model.
P.57 50 Speed of wire threading under local control in 0.1m/min.
P.58 125% Speed ratio between the winder motor and the torch motor.
P.59 5 Assistance supervision setting for MIG Arc-force in the event of disturbances.
P.60 12 Wire feed speed before starting the arc at 0.1m / min.
SOLTER
SOLDADURA S.L.
AEROPROCESS 20