10
2
HANDLE
BAR
1. Install four Wave Washers (175) onto the Left and Right sides of the Handle Bar axle, two on each side.
2. Slide the Left (10) and Right (11) Handle Bars onto the appropriate side of the axle. The handlebars have a
small sticker on them indicating L (left) and R (right). Make sure the handlebars are facing the correct
direction see illustration.
3. Install two Flat Washers (165) onto the two Hex Head Bolts (132) and install, and tighten, in the threaded
holes in the ends of the axle.
4. Connect the two wires (Left-60 to 61 & Right-59 to 61) on the L&R sides together and store the excess wire,
including plastic connectors, back inside the console mast. Place the rubber grommets (75) over the wire
and snap it into the hole in the console mast. Install the Handle Bar Covers (105 to 106) and (107 to 108)
over the Console Mast axle connections and secure with the eight Sheet Metal Screws (142).
