8
1
INCLINE
RAIL
& CONSOLE
MAST
1.
Install the Incline Rail Assembly (2) into the U-channel bracket of the Main Frame (1). Secure with the six
bolts & associated hardware as follows: From the sides install two Hex Head Bolts (133) with two Flat
Washers (164) and two Nylon Nuts (157). From the top install four Hex Head Bolts (135), four Split
Washers (182), four Flat Washers (170), and four Star Washers (183), and tighten with the Wrenches
provided (184 & 187). Connect the three wire power connector (48) and Sensor Connector (49) to the
mating connectors.
2.
Locate the Console Mast (12) and Console Mast Cover (96) and slide the Cover onto the Mast as far as
it will go. Make sure the Console Mast Cover is facing the correct way. At the top opening of the Main
Frame of the elliptical is a Computer Cable (50); Secure the free end of the twist tie that exits the bottom
of the console mast (12) to this cable. Pull the opposite end of this twist tie up through the console mast
(12) until the cable exits the top. Install the Console Mast (12) into the receiving bracket on the top of the
Main Frame (1). Pull slightly on the computer cable at the top of the mast while installing. This will ensure
the cable does not get pinched and shorted during console mast assembly.
3.
Put one Split Washer (180) onto the Long Hex Head Bolt (125) and install through the left side of the
receiving bracket into the Console Mast (12). Put the two Curved Washers (181) onto the two Short Hex
Head Bolts (132) and install through the front of the console mast. Using the Wrench (184), tighten the
bolts (132) first, and the bolts(125), and lastly the fourth bolt, which is pre-installed, firmly. These bolts
should be tightened as much as you possibly can. This is the main joint of the unit. if not tightened
sufficiently, this could lead to noise and instability issues.
4.
Plug all of the connectors into the back of the console; Computer Cable (50), two Hand pulse Cables
(56), Resistance switch wire (59) and Incline switch wire (61). Secure the Console (45) on the console
mounting plate with four Phillips Head Screws (141).
