CSE-H21 User’s Manual Ver. 1.2
Sollae Systems Co., Ltd.
- 23 -
http://www.sollae.co.kr
access the CSE-H21
ezManager Lock
If this parameter is set, CSE-H21 replies to the only host that has
parameters that is defined in the [Allowed Ethernet Address] or
[Allowed IP].
3.2.4
ezManager Operation example
ezManager can be used to change the IP address related items, the serial port setup value,
the serial port operation mode, and how to setup ezTCP. This section describes these
functions briefly. For more information, see the following sections.
The following example shows how to read and change ezTCP‟s basic functions. Try
changing ezTCP setup value according to the following sequence:
.
When the ezTCP power is turned on and the LAN cable is connected correctly,
pressing [Search ezTCP] or [Read] button will display the following window:
Figure 3-2 Searching ezTCP
If a network-attached ezTCP is detected, the following message will be displayed. If a
message pops up indicating that there is no response from ezTCP, check that the power
is turned on and the cable is connected correctly or make sure the firewall function on
your PC, then try pressing [Search] or [Read] button. (The protocol that ezManager uses is
UDP and its port is 50005. And its debugging port is 50006.)
Figure 3-3 ezTCP is found
If more than one ezTCP are detected, ezTCP‟s MAC ADDRESS will be displayed in the
[Search List] box on ezManager. Check if the MAC ADDRESS displayed in the [Search List]
window corresponds to that printed on ezTCP main body.
