Soligent S600 Series, Руководство пользователя

Страница: 11 / 24

3-3. Installation
：
Where to install. The power inverter should be installed in a location that
Meets the following requirements
：
3-3-1. Dry – Do not allow water to drip or splash on the inverter.
3-3-2. Cool – Ambient air temperature should be between 0
℃
and 33
℃
, the
cooler the better.
3-3-3. Safe – Do not install in a battery compartment or other areas where
flammable fumes may exist, such as fuel storage areas or engine
compartments.
3-3-4. Ventilated – Allow at least one inch of clearance around the inverter
for air flow. Ensure the ventilation openings on the rear and bottom
of the unit are not obstructed.
3-3-5. Dust – Do not install the Inverter in a dusty environments
where are dust, wood particles or other filings/shavings are present.
These dust can be pulled into the unit when the cooling fan is
operating.
3-3-6. Close to batteries – Avoid excessive cable lengths but do not install
the Inverter in the same compartment as batteries.
Use the recommended wire lengths and sizes (see section 3-6).
Also do not mount the Inverter where it will be exposed to the
gases produced by the battery.
These gases are very corrosive and prolonged exposure also will
damage the Inverter.
WARNING!
Shock Hazard. Before proceeding further, carefully
check that the Inverter is NOT connected to any
batteries, and that all wiring is disconnected from any
electrical sources. Do not connect the output terminals
of the Inverter to an incoming AC source.
9