10
6.2.
Connecting the oven to the electrical system
ATTENTION!
Connecting the oven to the electrical system consists in putting the plug in the
appropriate plug-in socket of electrical installation (
230V 1N-50Hz).
This socket, should be in
a place accessible to the user of oven, after installation of device to the kitchen furniture.
Protective conductor
must be obligatory connected to the socket
and oven
, because of the
danger of electric shock. The electrical installation of power supply of oven, must comply
with
current consumption
approx.
16A,
should have a cross section of wires min.
3x1.5
mm2 and it should be equipped with properly matched protection.
Information for electrical installer
Before connecting
the oven
to a mains socket, one should check:
The value of the voltage (is located on the nameplate)
The compatibility of cross-sections of the wires in the electrical installation with given
in the point 6.2.
When connecting the oven
is prohibited
to use any extension cords, switching devices
(connectors) etc., because may cause a fire. The connection cable cannot come into contact
with hot or sharp parts of the construction of oven. All changes in the electrical system can
be carried out only by a qualified electrician.
In the case of
damage to the power cord
, one should replaced it at a service point
intended for this purpose.
One should pay attention, in order to power cord was not twisted or hard-pressed by
equipment.
The connection cable must be regularly inspected by an authorized person. In the
event of necessity to
replacing the power cord,
this must also be done by a specialist.
7.
OPERATING INSTRUCTIONS
7.1.
Before the first operation of the oven
•
Carefully clean the inside of the chamber and remove any remains of packing.
•
Remove unnecessary equipment at a given moment.
•
Please open the window or run the ventilation, because the first switching on may be
associated with a temporary emission of odours. One should warm up the oven in the
temperaturę 250°C approx. 30 minutes.
•
Please carry out the first usage, keeping any hints from the owner's manual.
Protective devices:
If the oven is connected and used in accordance with the instruction
manual, then there is no need to use additional protective devices.
The oven has a built-in
2
fans, after opening the door is visible
circulating fan
of chamber
of oven, and inside the housing is installed the
cooling fan
.
Fan
operation relies on cooling
down to a safe temperature of door of oven, housing parts, and control devices. It switches
on automatically, when you turn on any heater (heating element), when the housing
temperature exceeds the set value and operates until cool down of the housing of the oven.
Fan speed is adjusted automatically.
