Sole Diesel SVT 10, Руководство оператора

Страница: 6 / 8

SETTINGS
6
Operator’s Manual SVT Panels
Revision 1. 07/2017
3. Settings
3.1. Tachometer calibration and replacing the light bulb
The tachometers supplied with the panel are calibrated in the factory. The user must only
calibrate tachometers purchased as spare parts.
The tachometer can be calibrated with the switch at the rear. To know its position, the
pulley ratio must be calculated.
After calculating the pulley ratio, refer to the table (approximate value, if required) and
rotate the tachometer switch.
If the pulley ratio is not exactly the same as in the table, the calibration
must be completed with the Calibrator (CAL). Introduce a small flat
screwdriver into the calibrator (CAL) at the rear of the meter. Carefully
calibrate the mechanism moving the meter needle forwards or
backwards until it corresponds to the engine speed.
Unscrew the cap of the light bulb (rear of the meters) and change the light
bulb.
4. Service Assistance
For an updated list of our distribution network, visit Dealers section in our web page
www.solediesel.com. Or request this information by contacting Solé Diesel at:
e-mail: info@solediesel.com
Phone: +34 93 775 14 00
Tachometer Switch
Interruptor del Tacómetro