![background image](http://html1.mh-extra.com/html/sole-diesel/svt-10/svt-10_operators-manual_1314487005.webp)
PANEL PARTS
5
Operator’s Manual SVT Panels
Revision 1. 07/2017
2.
Panel parts
PRE-HEATING
The LED light turns on when the pre-heating spark plugs receive power. It turns
off after a few seconds to indicate that the engine is ready for start-up.
NOTE: The only purpose of this LED is to inform the user, it does not act on the
engine. The pre-heating spark plugs keep working even if the LED light is not on.
BATTERY CHARGING FAULT
The LED and the buzzer are activated when the alternator is not charging the
battery.
NOTE: When the engine is off, the alternator is usually not charging and this
alarm is on.
HIGH COOLANT TEMPERATURE
The LED and the buzzer turn on when the coolant temperature is too high.
NOTE: This alarm should never appear during normal engine operation.
LOW OIL PRESSURE
El led y el zumbador se encienden cuando la presión de aceite es demasiado
baja.
NOTA: Cuando el motor está apagado es normal que la presión del aceite sea
baja y esta alarma esté funcionando.
HIGH SEAWATER TEMPERATURE
This panel part is prepared to install a LED that turns on when the seawater
temperature at the exhaust outlet is more than 70ºC. In addition, in case of
alarm, the buzzer will emit a sound. It is necessary to install the kit alarm
temperature exhaust ref. 60900280.
FIVE POSITION KEY SWITCH
The contact key switch is directly connected to the battery (PIN 30) and
depending on its position (STOP, OFF, ON, PRE-HEATING, START), the key supplies
certain pins/connectors where the different electronic devices are connected.
TACHOMETER AND HOURMETER
The tachometer displays the revolutions of the engine and is adjusted for each
engine model. If the panel is to be used for an engine other than Solé Diesel
models, the tachometer should be adjusted (see Section 2.2.4).
The screen located at the bottom of the clock is the work hours counter.
The hourglass blinks when its counting the work hours; if it does not blink, it
is not counting.
COOLANT TEMPERATURE GAUGE
The thermometer indicates the coolant temperature.
The pressure meter indicates the pressure of the lubrication
circuit
.
VOLTMETER
The voltmeter indicates the voltage of the engine electrical installation,
generated by the alternator.
NOTE: During the start-up stage, when the key switch is at the ON and
PREHEATING POSITION, the meter displays the battery voltage, as the
alternator is not yet working.
Содержание SVT 10
Страница 1: ...Rev 1...
Страница 2: ...2 Operator s Manual SVT Panels Revision 1 07 2017...
Страница 7: ......
Страница 8: ...Rev 1...