IMPORTANT:
Before starting equipment, test the water as you would with any pool to balance the water (to estimate the
number of gallons in your pool, go to
www.poolchemicalcalculator.com
)
-Total Alkalinity: 80-120ppm
-pH: 7.2-7.6
-Calcium Hardness: 200-400 ppm
-Copper: less than .4 ppm
ACTIVATE EQUIPMENT:
Turn on equipment so water is circulating TO THE POOL.
TREAT POOL WATER:
You will need to establish a low chlorine residual (0.5 - 1.0 ppm)
IMPORTANT!!
Run the entire system (pump, filter and oxygen generator) CONTINUOUSLY FOR 48
HOURS OR LONGER UNTIL THE POOL WATER IS PERFECTLY CLEAR
MISCELLANEOUS:
-Remove any fountain attachments on the pool return fitting. Oxygenated water must be injected directly
into the water. It will lose its effectiveness if a fountain fitting is used.
-Rotate the return fitting inside pool so it facing on a 45 degree angle pointed down and to one side to
create a circular flow to the water inside the pool and so the oxygen bubbles are pushed lower into the
water.
INITIAL WATER TREATMENT
7
OPERATION
Run System 8 hours daily at 2-3 LED lights on
Salt System
Maintain low chlorine level of up to 2-3 ppm
Test water weekly
Take water sample to dealer monthly
