1. Important Safety Instructions
Read and Follow All Instructions
All electrical work must be performed by a licensed electrician and conform to all national, state, and
local codes. Improper use or installation can badly harm the unit and its surroundings.
When installing and using this electrical equipment, basic safety precautions should always be
followed, including the following:
DO NOT OPEN THE SEALED COVER OF THE SALT POWER SUPPLY
– NOT A SERVICEABLE UNIT
● Power must be shut off at the circuit breaker before performing any wiring. Be sure to follow
Local and NEC electrical codes. To provide safe operation, the power supply must be
properly grounded and bonded.
●
WARNING – To reduce the risk of injury, do not permit children to use this product
unless they are closely supervised at all times.
● The Power Supply must be mounted
vertically
on a flat surface and at a minimum horizontal
distance of 5 ft (1.5m) (or more, if local codes so require) from the pool/spa.
●
WARNING –
Risk of Electric Shock. Connect only to a branch circuit protected by a
ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot
verify that the circuit is protected by a GFCI.
●
WARNING – The Power Unit comes with a prewired junction box which is connected to
a a power source, which will turn the pump and Power Unit on and off together. As all
individual wiring set ups are unique, have the Power Unit wired to the load side of the
external timer or automation box by a qualified person. It is very important that the
power supply is only powered when the pump is running.
●
WARNING – To reduce the risk of electric shock, replace damaged cord immediately.
●
WARNING – The wiring of the unit must be performed according to the wiring
instructions of this manual.
●
WARNING – A build-up of flammable fumes can result in a hazardous condition if the
cell is allowed to operate without flow. This device must be operated only with the
inline flow sensor provided.
●
WARNING – Ensure that equipment and materials used in or around the pool and spa
are compatible with salt-based sanitation systems. Certain materials may be
susceptible to salt and chlorine damage.
● ALWAYS ADD ACID TO WATER, NEVER WATER TO ACID.
● SAVE THESE INSTRUCTIONS.
Adding the salt to the pool water
BEFORE
starting the salt system is required. The system could show
error lights on the power supply if there is no salt circulating in the pool water for several hours before
starting the system.
The “Low Salt” light may remain lit for up to 24 Hours until salt is fully dissolved in the water.
IMPORTANT!
ADD SALT TO THE POOL BEFORE STARTING INSTALLATION
2
