Solaxx Renessance, Инструкция по установке и эксплуатации

Страница: 9 / 12

MAINTENANCE
BULB REPLACEMENT
The UV bulb is rated for 13,000 hours of service and can be monitored through the blue viewing
ports at either end of the chamber. When the bulb requires replacement, follow this simple
procedure:
Shut off AC power to Renaissance before performing maintenance
Allow bulb to cool for 10 minutes before handling
A. Unthread and remove the end cap with the wire attached from the end of the UV chamber
B. Plug the 4 prong plug into the end of the UV bulb
C. Slide bulb back into chamber
D. Rethread cap back onto chamber fitting (hand tighten only)
IMPORTANT:
HANDLE THE BULB BY THE ENDS ONLY AND AVOID TOUCHING THE CLEAR GLASS OF THE
BULB. IF POSSIBLE USE COTTON GLOVES TO HANDLE BULB TO AVOID GETTING OILS FOM
HANDS ON THE BULB. SKIN OILS ATTACH TO THE BULB AND SHORTEN ITS EFFECTIVE LIFE.
IF BULB IS TOUCHED, WIPE CLEAN WITH A SOFT CLOTH AND RUBBING ALCOHOL.
CLEANING THE QUARTZ SLEEVE
The quartz sleeve inside the UV chamber encases the UV bulb
and should be cleaned while winterizing the system, or annually if
system is installed on a pool running 12 months. The quartz
sleeve is brittle and can be cracked, chipped or broken if it is not
handled with care. Do not remove the sleeve or attempt to
scrape or scrub the sleeve as it could crack or break it.
-After removing the top chamber as shown in WINTERIZING
section, turn the chamber over so the openings face up.
-Using CLR or Lime Away or a comparable cleaning product
(available at grocery stores or home centers), pour into the
chamber to cover the quartz sleeve with the liquid and allow to
soak for 30 minutes. Dispose of cleaning solution by following
instruction on the cleaning solution container.
-Rinse the quartz sleeve with isopropyl alcohol to remove any
remaining residue from the sleeve.
-Rinse the sleeve again with water.
-Allow to dry before reinstalling.
B C D A
Fill to here so
quartz sleeve
is covered.
9