SolaX Power HV10230, Руководство пользователя

Страница: 15 / 23

24 25
4. Installation
4. Installation
1) Shut down the T-BAT system (refer to Section 5.4 Shutting Down T-BAT
System of User Manual on page 30)
2) Remove the lock cover
a. Pull the back end of the lock cover using a finger or an instrument.
b. Remove the lock cover and store for later use
3) Push the plastic button on each end of the power cable in the direction
of the arrow
Notes for Unplugging Power Cables
Lock Cover
CAUTION!
Do not plug or unplug the power cables when the T-BAT system is
on. Doing so could result in an arc discharge which could cause
serious harm.
4) Unplug the power cable
+
-
+
-
4.5.2 Connecting the COMM Communication Cable
1) Connect the COMM communication cable (E) from the right side of the BMS to
the COM1 communication port that is on the right side of the battery module.
2) Connect the COM1 of the upper battery module on the right side to
COM1 of the follow-up battery module.
The wire order of the communication cable is as follows:
1 2 3 4 5 6 7 8
1) Orange stripes on white
2) Orange
3) Green stripes on white
4) Blue
5) Blue stripes on white
6) Green
7) Brown stripes on white
8) Brown
3) Tighten the plastic screw nut which is set on the cable with a rotation wrench.
4.5.3 Connecting the Ground Wire
For BMS and 3-4 battery modules:
Connect the ground wire from the BMS to the battery module
Note: 10AWG ground wire is required for grounding
Sequence
1
2
3 4 5 6 7 8
COM1
COM2
VCC_1
GND VCC_2 CANH CANL GND N- P+
VCC_1
GND VCC_2 CANH CANL GND N- P+