Solaris SunPump MACHRW010W, Руководство по установке, Страница: 12 / 32

5.1.The first step Daub the heat conduction silica gel spreads in the front of sensor, and insert
into the detector.
5.2.The second step
use < 5 pin to push the detector into the end of the detector against the
end of the sensor, and marks on level of the pin and the detector.
5.3.The third step
putout the pin the position of mark to be at the same level with the inlet of
detector check whether the sensor is inserted to the pipe terminal.
5.4.The fourth step the inlet of the detector is sealed with the glass silica gel, and keep the inlet
of the detector upwards and uprightness about an hour
6. Selection of Electrical Wire
6 . 1
Voltage drop may occur due to the large current draw during compressor starting, and may be result in the
compressor is difficult to stat. So we recommend selecting the wire specification from the table below.
6 . 2
Specification Table of Electrical Wire
Mode:MACHRW
010W/(B01)
020W/(B01)
030W/(B01)
Wire Specification
Circuit breaker
Voltage
2
2.5mm
10AMP
2
2.5mm
2
2.5mm
14AMP
20AMP 208~230V/1PH/50Hz
8
The head
of sensor
The heat
conduction
silica gel
The first step The second step The third step The fourth step
The heat
conduction
silica gel
The head
of sensor
< 5 pin
< 5 pin
The heat
conduction
silica gel
< 5 pin
Detector
Tank Tank Tank Tank
Detector
The head
of sensor
Detector
Detector
The head
of sensor
Note:
1) Tubing pipeline should be separate test pressure, must not test with hot water unit or tanks.
2) The
3) The
.
4) Water can drain from the pressure relief device drainage pipe, and the piope keep open to
atmosphere.
5) The pressure relief device regularly move to remove the calcium carbonate, and prove that
the device is not plugged.
6) Installation of one-way valves, filters and pressure relief device, valve body arrow as same
as flow direction .
7) The pressure relief device discharge pipe should be installed in the frost-free environment in
A continuous down way.
Water system allows working pressure range: 0.2-0.7 MPa.
Water system allows working temperature range: 5-60
5. Installation of the temp detector
208~230V/1PH/50Hz
208~230V/1PH/50Hz