Solaire GODDESS Royal Collection T6000 S, Инструкция по эксплуатации

Страница: 10 / 16

10
6. Maintenance
1. GODDESS Royal Collection ™ Unit.
a. There is minimal maintenance to perform on the GODDESS Royal Collection™ unit. Make sure you keep the motor
unit as far away from your spraying area as possible.
b. Every night wipe over GODDESS Royal Collection™ unit with a damp cloth.
Please Note: Ensure no excess water is used as this will short circuit the unit.
c. Please see maintenance cleaning video at: http://www.solaire.com.au/Main.asp?_=Sunless Education
2. Air Filter.
a. Remove the air filter on the side of the unit and wash at the end of every week.
3. Air Hose.
a. Wipe the air hose daily with a damp cloth and store in a clean dry place.
4. T6000 Spray Gun - Daily Clean.
a. It is important to clean your T6000 Spray Gun daily.
b. At the end of the day or when the equipment will not be used any more, disconnect the T6000 Spray Gun from the
air hose.
c. Carefully unscrew the cup. If there is remaining solution, either close the cup with a lid, or pour the remaining
solution into a proper storage container.
d. Rinse the cup under warm running water until clean.
e. Turn the gun upside down and allow warm running water to run into the plastic tube, pull back the trigger and allow
the water to flow out of the nozzle. Continue until clear.
f. Fill the cup about ¼ full with AIRBRUSH CLEANER. Reconnect the T6000 Spray Gun to Air Hose. Turn on
the GODDESS Royal Collection™ Unit. Direct the T6000 Spray Gun to a safe area and spray the AIRBRUSH
CLEANER through the T6000 Spray Gun until the cup is empty and until the Spray becomes CLEAR.
g. Turn off the GODDESS Royal Collection™ Unit. Disconnect the T6000 Spray Gun. Unscrew the cup.
h. Start to dismantle your T6000 Spray Gun.
i. Unscrew and remove the Air Cap Ring (#1, Diagram on page 6). Rinse the threads under warm running water. Wipe,
the threads and dry. Add a small amount of Spray lube to the threads.
j. Remove the Air Cap (#2, Diagram on page 6). Rinse under warm water. Wipe clean, Dip into AIRBRUSH CLEANER
and dry.
k. Remove the plastic air plate (#5, Diagram on page 6) Rinse under warm water. Wipe clean.
l. Reinstall the three pieces you just removed by reversing the removal procedure. Your T6000 Spray Gun should be
ready for the next use.
m.Please see Spray Gun maintenance cleaning video at: http://www.solaire.com.au/Main.asp?_=Sunless Education
®
®