Solahart Streamline 270MDV, Руководство пользователя

Страница: 49 / 56

COMMISSIONING
49
If the red LED does continue to emit a rapid pulse for longer than ten (10) minutes, this may indicate
water is not circulating through the solar collectors and solar circuit:

switch off the electrical supply at the power outlet to the solar control unit

repeat the procedure to bleed the solar collectors

switch on the electrical supply at the power outlet to the solar control unit.
DIAGNOSTIC FEATURES OF THE SOLAR CONTROLLER
A solar monitor is located on the side of the solar control unit and houses a green and a red LED.
The green LED, marked “Solar”, indicates the current operational mode of the solar water heater and the red
LED, marked “Attention”, may indicate a potential fault mode.
The green LED will emit either a constant glow, a constant
pulsing or a series of flashes, with a 2 second interval
between each series.
The red LED will emit either a constant glow, a constant
pulsing or a series of flashes with a 2 second interval
between each series. A constant glow or pulsing does not
necessarily mean there is a fault with the system. A series of
flashes indicates there may be a particular fault condition with
the system.
The modes are:
Flashes Operational Modes Flashes Indicator or Fault Modes
solid green
(remains on)
Standby mode
solid red
(remains on)
Hot sensor temperature
greater than 130°C
green
slow pulse
Standby mode
(power on for less than 48 hours) red
rapid pulse
Temperature rise across collector
greater than 45°C
(circulator at full speed)
green
rapid pulse
Circulating water through collectors 3 x red Hot sensor in collector
– short circuit
3 x green
Circulating water through collectors
(power on for less than 48 hours)
4 x red Hot sensor in collector
– open circuit
no green
(remains off)
Power outage or call for service 5 x red Cold sensor
–short circuit
6 x red Cold sensor
– open circuit
If the power supply to the solar control unit is on and the green LED is off or the red LED is flashing, this
indicates there may be a fault with the water heater. The red LED may emit from three to six flashes in each
series of flashes. A constant glow or pulsing of the red LED does not necessarily mean there is a fault with
the system.
Note: During periods of high solar radiation and if the circulator activates after having been off, such as
during start up if the solar collectors have not been covered, it is possible the red LED may emit a rapid
pulse for a period of up to ten (10) minutes. This does not indicate a fault. Refer to
“Solar Controller
Operation at Start-
Up”
on page 48 for the possible green and red LED pulsing sequence during start up
procedure.
If the red LED continues to emit a rapid pulse for longer than ten (10) minutes, or emits a series of flashes,
then count the number of flashes and phone your nearest Service Department or Accredited Service Agent
to arrange for an inspection.