Solacom SS7, Быстрый старт

Страница: 30 / 66

Getting Started with SS7
18
Parameter Values
RemoteTxCOTToneID 62 (0–63) — tones from the GeneratedTone
table that will be played on this trunk group
when a ContinuityTest is performed.
PercentageOfOutgoingCOT 0 (0–100) — the percentage of outgoing
calls that COT will be performed on.
6 Use the
MoveSpanToTrunkGroup
command to add additional spans to the
trunk group. For example, to add the remaining 15 spans of the T1 card in
shelf 25, slot 2 to the SS7 trunk group, proceed as follows:
MoveSpanToTrunkGroup 25,2,1,3,48
MoveSpanToTrunkGroup 25,2,2,3,72
MoveSpanToTrunkGroup 25,2,3,3,96
MoveSpanToTrunkGroup 25,2,4,3,120
MoveSpanToTrunkGroup 25,2,5,3,144
MoveSpanToTrunkGroup 25,2,6,3,168
MoveSpanToTrunkGroup 25,2,7,3,192
MoveSpanToTrunkGroup 25,2,8,3,216
MoveSpanToTrunkGroup 25,2,9,3,240
MoveSpanToTrunkGroup 25,2,10,3,264
MoveSpanToTrunkGroup 25,2,11,3,288
MoveSpanToTrunkGroup 25,2,12,3,312
MoveSpanToTrunkGroup 25,2,13,3,336
MoveSpanToTrunkGroup 25,2,14,3,360
MoveSpanToTrunkGroup 25,2,15,3,384
The
MoveSpanToTrunkGroup
command has the following parameters:
Parameter Values
ShelfNumber 25 (0–31)
SlotNumber 2 (0–15)
SpanNumber 1 (0–15)
TrunkGroupNumber 3 (0–4095)
StartCIC circuit identification code.
7 Enable the spans. For example:
EnableSpan 25,2,-1
8 View the configuration. For example:
DisplayTrunkGroupChannels 3
3.4.2 Channel-based Trunk Group Configuration
EdgeIQ allows an operator to configure trunk groups with a small number of
channels that can be sent to a different destination. The following commands can be
launched at the SS7 channel level: