Installation Guide Wiring Reference
(SEE HOW TO TEST VEHICLE WIRES AT THE END OF THIS MANUAL)
CN1 (MAIN)
These Wires are limited to 1 amp. Do not connect to High Current vehicle wires. If you are installing to a
vehicle where high current is needed please use Plug in Relay Pack.
RED - (+) 12V INPUT
-
This wire is the 12V(+) input for the remote starter. Connect this wire to a 12V(+) Constant wire on
the vehicle.
BLACK
-
This wire is the system ground input. Connect this wire to bare metal on the vehicle chassis. Solace recommends a
kick panel and scraping away any paint. All your ground connections from the remote starter and any add-ons such as alarm
sensors, or bypass module should be grounded at the same point.
PURPLE - (+) START OUTPUT
-
This wire will send out a 12V(+) pulse during crank. Connect this wire to the (+) Starter
wire on the vehicle.
ORANGE - (+) ACCESSORY OUTPUT
-
This wire sends out 12V(+) signal but shuts off during the crank cycle. Connect
this wire to the (+) Accessory wire on the vehicle.
PINK - (+) IGNITION INPUT/OUTPUT
-
This wire sends out 12V(+) signal during remote start and during the crank cycle.
This wire is also the ignition feed for the remote starter and is required for programming. Connect this wire to the (+) Ignition
wire on the vehicle.
PINK/WHITE - (+) SELECTABLE OUTPUT
-
This wire is programmable in Menu 2-01. Whatever it is programmed for it
will duplicate the output for a 2nd wire. It is default set to (+) Ignition. Connect this wire to either 2nd Ignition, 2nd Starter, or
2nd Accessory. Please be sure to program for the according wire on vehicle. This wire can also be programmed to control a
(+) Positive trunk release, (+) PUSH TO START BRAKE output, or SIREN. Connect to a positive trunk release circuit if needed
and program Menu 2-19 to the desired setting.
CN2 (LOCKS)
GREEN- (-) 325mA LOCK OUTPUT
-
This wire will send a (-) pulse whenever lock is pressed. Connect this wire to the
vehicle’s NEGATIVE lock wire. DO NOT connect to any wire other than negative. This is a programmable output that can be
programmed for timing, number of pulses, and when it turns on. Please see Menu 1-02, 1-03, 1-05, 1-12, and 1-13
EMPTY- (+) 1 AMP POSITIVE OUTPUT
-
This empty spot will send a constant 12V(+) output that can be used to trip a
relay or a Power Door Lock Module. DO NOT use this wire to drive reverse polarity door locks. DO NOT connect to a high
amperage circuit as damage may occur.
BLUE- (-) 325mA UNLOCK OUTPUT
-
This wire will send a (-) pulse whenever unlock is pressed. Connect this wire to the
vehicle’s NEGATIVE unlock wire. DO NOT connect to any wire other than negative. This is a programmable output that can
be programmed for timing, number of pulses, and when it turns on. Please see Menu 1-02, 1-04, and 1-05.
