7 GreenWay™ installation & operation manual 0410 MKTG-IM-GREEN-002
Mounting Battery Enclosure and Routing PV and Luminaire Cables
Route the ends of the solar PV cable and the Luminaire cable through the hole and grommet at the back of the battery
box, as shown in Figure 9. Loosely fasten the brackets at the back of the battery box to the pipe of the solar panel
mounting, using four 1/4”–20 x 1/2” hex head bolts. Securely tighten each bolt. Position the cables so they extend
inside the battery box at least 12 inches (30.5 cm).
FIGURE 9
MOUNTING BATTERY BOX
FIGURE 10
ROUTING CABLES
PV Cable from PV Array
Luminaire cable from LED
Luminaire
Hole and Grommet
Bracket
Installing the Battery/Batteries
Loosely connect the battery harness to the battery terminals. When connecting the battery, connect the
positive terminal first (Red +). Protect the free (unconnected) ends of the battery harness from touching other
metal parts so they will not accidentally cause a short. Tighten the connection on both terminals. Place the
battery in the battery box. Connect the battery harness to the single aiSUN™ harness as shown in Figure 11.
Battery Harness - one for each battery
Black (
-
)
Red (
+
)
Gel Cell 100 Ah
NRGLife™ Battery
FIGURE 11
BATTERY AND BATTERY HARNESS
Installing Luminaire
For Ascot Fixture:
Connect the connector from the LED luminaire to the connector at the end of the luminiare load cable.
Slide the LED fixture onto the arm. Adjust the LED fixture for the desired tilt. Secure the LED fixture to the arm using the
socket head bolts (Figure 12).
For Shoebox Fixture:
Loosen the set screws that secure the slip fitter. Plug LED luminaire connectors together. Slip fixture over pipe (guide
excess wires into pole). Secure set screws. To adjust angle remove circular cover using Phillips screwdriver. Using a
socket wrench, loosen bolt to adjust angle to desired angle. Tighten bolt and replace cover (Figure 13).
