13 GreenWay™ installation & operation manual 0410 MKTG-IM-GREEN-002
Preventive Maintenance and Service
Tree Branch Clearing
Trim tree branches (and remove any other obstructions) in the vicinity of the solar panel(s) once every three
months.
Solar Panel Cleaning
The solar panel(s) should be cleaned periodically to insure optimum performance.
1. Using a non-streaking window cleaner and a soft cloth, thoroughly wipe down the solar panel(s) to
remove any dirt and grime that may have accumulated.
2. Dry the solar panel(s) with a soft clean cloth.
3. Repeat Steps 1 and 2, if necessary, until all dirt and grime have been removed.
Fuse Replacement
If the SOL GREENWAY® Light does not operate, check the fuse.
1. Open the battery box.
2. Remove the fuse cover on the fuse holder.
3. Remove the existing fuse, insert the new fuse, and replace the fuse cover.
4. Test the system.
5. Close the battery box.
LED Fixture Replacement
1. Remove the socket head bolts that secure the LED fixture to the arm (see Figure 14 for details).
2. Slide the LED fixture off the arm.
3. Disconnect the LED fixture from the load cable.
4. Insert the new LED fixture, following Steps 1 through 4 on page .
5. Open the battery box and press the white TEST button on the controller until a distinct click is heard and
felt. The LED fixture will illuminate for five minutes, and the red LED will begin to flash.
6. Close the battery box, and close the fixture cover.
Note: A plastic scraper may also be needed for removing bird droppings.
Note: Solar panels can get very hot when the sun is out. It is advisable to clean solar panels during
the early morning hours.
Note: If the fuse needs to be replaced, be sure to also check operation of the controller.
Note: The LED in the fixture is not serviceable. The entire LED fixture assembly must be replaced.
