6 GreenWay™ installation & operation manual 0410 MKTG-IM-GREEN-002
Arm Assembly
Assembling the Components
After the pole has been set and anchored, slide the arm assembly into the top of the pole (Figure 6a). Route the PV
load cable through bottom of the solar panel assembly pipe and out through the grommet and hole on the front of the
pipe (Figure 6b). Place the solar panel assembly on the top of the arm assembly. Swing the arm assembly so that the
light fixture (which will be attached to the end of the arm) is in the desired position (Figure 6c)
FIGURE 6
ASSEMBLING ARM ASSEMBLY AND PV ASSEMBLY TO POLE
Arm Assembly
Pole
Luminaire Load
Cable
Luminaire Load
Cable
PV Module Cable
Equator (Due South in
Northern Hemisphere)
PV Assembly
a
b
c
Riveting the Arm Assembly to the Pole and Solar Panel Assembly to the Arm Assembly
Verify that the arm is positioned so that the light fixture (which will be attached to the end of the arm) is in the desired
orientation. Using one of the pilot holes at the upper end of the pole as a guide, drill one rivet hole using a U.S. “W”
gauge (0.386-inch) drill bit (or use a 25/64-inch drill bit if “W” gauge not available). Drill through the pilot hole and then
through the arm assembly stock beneath the pilot hole (drill & rivet one pilot hole at a time). Place a drive rivet in the rivet
hole (Figure 7a). Pound the drive rivet into the hole (Figure 7b) until the head of the drive rivet is tight against the side of
the pole (Figure 17c). Install the three remaining drive rivets in the arm assembly.
Verify that the solar panel is positioned so that the solar panel is facing due south. Using one of the pilot holes at the
lower end of the solar panel assembly as a guide, drill one rivet hole using a U.S. “W” gauge (0.386-inch) drill bit. Drill
and rivot one pilot hole at a time following same instructions used for the arm assembly.
FIGURE 7
RIVETING THE ARM ASSEMBLY AND SOLAR PANEL ASSEMBLY
b
c
Drill holes
in pilot
holes
(4 places)
a
