8
Inserting the batteries
Procedure prior to first use or when changing batteries
•
Remove the two screws at the bottom
•
Open short side of the remote control
•
Lift the display face carefully
•
2 alkaline batteries 1.5 V IEC LR6 (AA)
•
Insert the 2 batteries in the compartment.
•
Note the correct polarity and carefully
close and replace retaining screws
+
Battery Compartment
-
2 Screws
1. Basic settings of the remote control
Turn "On" (the flame and clock icon is seen in the display) Remote On/Off button (1)
1) Press the clock button (2)
2) Use the
▲
or
▼
button (6/7) to set the exact current hour
3) Press the clock button (2) again and the minute digits will flash
4) Use the
▲
or
▼
button (6/7) to set the exact current minute
5) Press the clock button (2) again and the day of the week indicator (8) will flash
6) Use the
▲
or
▼
button (6/7) to set the current day of the week (1 = Monday)
7) Press the R button (4) and the entries will be stored.
2. Configuration Menu
The remote control has a configuration menu where the various basic parameters can be set,
depending on the preference of the users and their habits. Proceed as follows:
Press the button (1) to ensure that the remote control is in "antifreeze" mode. A cold symbol (14)
must be visible on the screen. Now press the - P (3) for about 3 seconds to move to the input
mode of the configuration menus. The large figure shown is setting number; the small figure to
the right is the adjustment for this setting. By pressing the arrow keys (6/7) you can adjust the
options until the desired selection is displayed. Pressing the P key again, the displayed value is
assumed for these parameters and the display changes to the next parameter. Continue selecting
until all 10 parameters are defined according to your wishes.
To exit from this menu, press the Start button (1) and return to the freeze protection mode or for
program execution, press the R-key (4) and enter run mode. If no key is pressed for 20 seconds,
the parameter menu is automatically exited.
