6
Wall mounting the device
The appliance must not be connected to the electricity whilst fitting to the wall
brackets.
Place the heater, with the front panel on the ground ensuring the surface you are placing it on
will not damage the heaters finish. If in doubt place a soft cloth down first. To release the wall
bracket, press the top part of the bracket on both sides at the same time the metal tabs slightly to
the left (Fig. 1) and hang the unit on the upper fixing of the wall bracket. Now lower the unit onto
the base lugs of the brackets.
With the air vents to the top, lower the heater into the bottom hooks (Fig. 2) The centre tabs of
the bracket will then locate into the slots before the top tabs will locate and lock ( Fig. 3). Press
the device now facing the wall , then snap the two movable plate tabs and the device is attached
to the wall bracket.
Should the unit need to be removed from the wall, then proceed as follows. First disconnect the
appliance from the mains. Now you can then access up behind the unit , to the two upper vertical
struts and press there the same time the two movable tabs to the right until it clicks button up
( fig , 1). Now the device can be taken from the holder.
Fig 1
Fig 2
Fig 3
Note: To release the unit from the wall bracket. Press the top tabs in together (Fig. 1). The heater
can then be dropped forward and lifted clear of the bracket.
Please ensure the heater is disconnected from the electricity supply before removing the heater
from the wall bracket.
