WER-401 Wireless SOHO Firewall Gateway
computer, hub, or switch. For any connection that will operate at 100 Mbps, you must use a Category 5
(Cat 5) rated cable, such as the Ethernet cable included with the wireless SOHO Firewall gateway.
Connect up to four computers directly to any of the four LAN ports of the wireless SOHO Firewall
gateway using standard Ethernet cables.
If your local network consists of more than four hosts, you will need to connect your wireless SOHO
Firewall gateway to another hub or switch: Connect any LAN port of your WER-401 wireless SOHO
Firewall gateway to any port of an Ethernet hub or switch using a standard or crossover Ethernet cable.
2.5.3 Connecting to Your Internet Access Device
To connect the wireless SOHO Firewall gateway to the WAN use the Ethernet cable provided with your
cable modem or DSL modem, connect the wireless SOHO Firewall gateway’s WAN port to the 10BASE-T
Ethernet port on your modem.
The attached modem device must provide a standard 10BASE-T Ethernet connection. The WER-401
wireless SOHO Firewall gateway does not include a cable for this connection. Instead, use the Ethernet
cable provided with your access device or any other standard 10BASE-T Ethernet cable. If you are using a
DSL modem, the modem’s connection to the phone line remains unchanged.
The Ethernet cable supplied by your ISP for connecting to your cable or DSL modem may be an Ethernet
crossover cable or a straight-through cable. You can push the normal/uplink button in the wireless SOHO
Firewall gateway to connect the modem well.
2.5.4 Connecting the Power Adapter
To connect the wireless SOHO Firewall gateway to the power adapter:
1. Plug the connector of the power adapter into the 5 VDC adapter outlet on the rear panel of the
wireless SOHO Firewall gateway.
2. Plug the other end of the adapter into a standard wall outlet.
3. Verify that the POWER LED on the wireless SOHO Firewall gateway is light.
2.5.5 Verifying Power and Connections
After applying power to the wireless SOHO Firewall gateway, complete the following steps to verify that
power is correctly applied and that you have the proper connections:
1.
2.
When power is first applied, verify that the Power LED is steady on (green and not blinking).
After approximately 30~60 seconds, verify that:
2-4
Hardware
Setup
Содержание WER-401
Страница 1: ...WER 401 Wireless SOHO Firewall Gateway User s Guide Version 1 01 November 2001 ...
Страница 34: ...WER 401 Wireless SOHO Firewall Gateway Figure 5 1 Internet Setup 5 2 The Basic Setup Screens ...
Страница 76: ...WER 401 Wireless SOHO Firewall Gateway Figure 7 3 Services The Firewall Screens 7 7 ...