Software House iSTAR Edge, Инструкция по установке и быстрому запуску

Страница: 5 / 26

Overview and Introduction
5

4 reader model, 8- I8 and 8- R8 allowed to be configured on any of the three RS-485 ports or
the optional 2 RM-4s.

Special purpose inputs:

Tamper (from enclosure door)

Main AC fail (from apS)

Low external battery (from apS)

FAI Supervision State (J40 F input)

FAI Relay Control

FAI Key Supervision State (J40 K input)

Onboard battery low

3 RS 485 serial ports.

USB Ports

2 USB host ports. (These are the wide and flat USB connectors used by memory sticks,
used when the iSTAR Edge is the host of the attached devices.)

1 USB device port. (This is the square connector used when the iSTAR Edge itself is the
client device.) (not currently used)

The only use of USB in the first version is to import encryption keys, in the same way as
iSTAR eX.
Communications

One 10/100 Ethernet port.

No secondary communication path.

Full 256 bit AES encryption, as with iSTAR eX

Can cluster with other iSTAR Edges

Can cluster with iSTAR eXs
FAI

Fire Alarm Interlock - When the F input is true, FAI activates relays that are enabled for
FAI by individual enable switches.

Latch option is available by switch control. If the selected relays are latched, they will be
cleared to normal by the key (K) input.
Onboard controls

LCD with backlight for diagnostics.

Rotary switch for diagnostics, as with iSTAR eX.

LEDs for serial, Ethernet, power and relay state.

Two power LEDs: one super bright LED that is on when the enclosure door is closed,
and one green LED that is always on when main power is present.

Relay activation LEDs are not affected by enclosure door.
NOTE
The following 4 inputs to the host are determined by the firmware. There is no actual
wiring to the iSTAR Edge board.