Software House iSTAR Edge, Инструкция по установке и быстрому запуску

Страница: 10 / 26

Installation Requirements
10
Power Requirements
The standard iSTAR Edge uses a UL Listed 603 External Power Supply, such as the Software
House apS or uses a Power Over Ethernet (PoE) injector with UL listed surge protector.
To ensure adequate power, calculate the total power requirements of iSTAR Edge and its
related hardware, as follows.

Add the total current power for components in the system (modules, relays, optional
modules, readers, and wire resistance).
iSTAR Edge Components and Boards
Table 3 shows the power requirements of iSTAR Edge components and attached boards.
a
RM-4 board has only been evaluated by UL with RM Series readers (RM 1,2,3)
b
RM-4E boards have only been evaluated by UL for use with RM-DCM-2 enclosure.
iSTAR Edge Input Power Rating
The iSTAR Edge has the following input ratings when using an external power supply:

12 VDC, 3.8 A

24 VDC, 3.1 A
Individual/Total Loads

RS-485 Reader Power Outputs: 10.6-12.5 VDC, 1.5 A max each.

Wiegand Reader Power Outputs: 10.6-12.5 VDC, 350 mA max each.

Total of all Reader and AUX outputs combined (RS-485 & Wiegand) not to exceed 1.5 A

Four (4) activated relay coils = 100 mA, 25 mA/relay

One I/8 module – 12 VDC, total= 125 mA

One R/8 module – 12 VDC, total= 325 mA (125 ma + 25 mA for each active relay (max 4))

R/8 relay contact ratings – 30 VDC at 3A (resistive)
Table 3: Component and Board Power Requirements
Component/Board Current Draw at 12VDC
iSTAR Edge 400 mA with LCD - no load
RM-4 board
a
80 mA without LCD - no load
180 mA with LCD - no load
RM-4E board
b
125 mA - no load
I/8 board 125 mA - no load
R/8 board 150 mA - no active relays.
Add 20 mA for each active relay