GW33H7-0#ls
Readdir ’/’
256 2020-01-01, 0:00:00 /.
256 2020-01-01, 0:00:00 /..
256 2020-01-01, 0:00:00 /etc
GW33H7-0#ls /etc
Readdir ’/etc’
256 2020-01-01, 0:00:00 /etc/.
256 2020-01-01, 0:00:00 /etc/..
124 2020-01-01, 0:02:38 /etc/gw.cfg
165 2021-05-06, 11:47:59 /etc/network.cfg
157 2021-05-05, 12:11:39 /etc/gsm.cfg
254 2021-05-06, 11:47:59 /etc/system.cfg
GW33H7-0#
GW33H7-0#cat /etc/gsm.cfg
Show file ’/etc/gsm.cfg’ :
[gsm]
apn = gprsa.softlink
pin = 1234
useip = true
usegps = true
synctime = false
pingip = 172.16.17.1
pingperiode = 60
pingreqcount = 2
pingreqtimeout = 10
GW33H7-0#
Commands for controlling the filesystem are intended mainly for manufacturer and it is
strongly recommended
not to use them
without detailed knowledge of the module function. Only using of the ”cat” command to check
the current module configuration can be useful in normal operation.
3.4.8
Commands of ”sys”, ”disp” and ”cc” subsystems for module initial setting and diagnostics
The commands of these three subsystems are used for the initial setting of the module during the production of its
motherboard (”sys”), display (”dis”) and radio chip (”cc”).
It is strongly recommended not to use these commands during common operation.
3.4.9
Command of ”ntp” subsystem for setting of time synchronization
This group of commands can be used for setting of time synchronization subsystem (RTC) from network servers of
the NTP (Network Time Protocol) system. There are following commands:
GW33H7-0#ntp?
Help :
rest
: restart
info
: NTP info
ena
: NTP enable
srv1
: NTP server 1
srv2
: NTP server 2
srv3
: NTP server 3
write
: save configuration
deb
: NTP info
?
: show help
GW33H7-0#ntp info
Time synchronization from NTP servers can be enabled/disabled by using of
”ntp ena [0/1]”
command.
WB169-RFG
21
