Softing PBpro ETH, Руководство пользователя

Страница: 31 / 36

Chapter 3 - PBpro ETH Adm inistration
PBpro ETH - User Guide 31
To assure that only authorized personnel may perform a reset to factory settings this
action requires physical access to the PBpro ETH.
Important
Reset to factory settings is an ultimate means to regain access to a
device with an unknown password. The internal reset button is a very small
and sensitive component not meant for regular use. Use this button with
extreme care and only in case of necessity. Be careful not to push too hard.
This may damage the button and can also lead to permanent failure of the
PBpro ETH. Such damages are not covered by warranty.
To reset, proceed as follows:
1. Remove power from the PBpro ETH
2. Carefully insert the tip of a ball pen into the hole labeled "Reset".
Figure 15: Activating the internal reset button with a ball pen (shown at an open
device)
3. While gently holding down the ball pen reassert power to the PBpro ETH.
4. After a few seconds an LED (single channel device:"RUN" , multi channel device:
"CON2") starts flashing 10 times per second.
5. As soon as the LED starts flashing you can remove the ball pen.
6. The reset process then takes roughly one minute with various LEDs flashing.
7. Finally, the "RUN" LED will shine solid green, indicating that PBpro ETH is operational.