Chapter 6 - Asset Management
Version EN-092019-1.21
39
9. Click
[Continue]
.
The window
Select Timeouts for pnGate PB / mbGate PB
is opened.
10. Set timeouts for Modbus Gateway (Timeout for Connect and Max Idle Time). In most cases default
settings can be used.
11. Click
[Apply]
The configuration wizard is closed. In the
Control Panel
the node name is shown on the left side
underneath
pnGate PA / mbGate PA
. The question mark on a yellow background means that the
connection to the Modbus Gateway has not yet been tested.
12. Click
[Apply]
in the
PROFIBUS Control Panel
to save all settings and confirm with
[Yes]
.
The PROFIBUS Control Panel tests the connection to the Modbus Gateway. After a short while, the
yellow question mark is replaced by a green check mark. If a red cross appears instead, check the
network cables and the IP settings of your PC and the mbGate PA/mbGate PB/mbGate DP. Ensure that
the PC and the Modbus Gateway are on the same IP subnet.
13. Click
[OK]
to close the
PROFIBUS Control Panel
.
