socomec Green Power 2.0, Инструкция по установке и эксплуатации

Страница: 5 / 56

5 EN
Operating modes 'MODULYS GP' 100 kW UL - Ref.: IOMMODGPXX09-EN 03
1. SAFETY STANDARDS
1.1 IMPORTANT SAFETY INSTRUCTION
SAVE THIS INSTRUCTION - This manual contains important instructions for models M4-S-100-HCA0, M4-S-125-
HCA0 and options, that should be followed during installation and maintenance of the UPS and batteries.
This manual should be kept carefully in a safe place near the UPS, so that it can be consulted by the operator at
any time for any information that may be needed regarding correct use of the unit. Read the manual carefully before
connecting the unit to the a.c. mains supply and to the downstream appliances. Before the UPS is put into commis-
sion, the user must be perfectly familiar with its operation, with the position of all the controls and with the technical
and functional characteristics of the unit, so as to ensure there will be no risk to any persons or to the appliance itself.
NOTE!
Any work carried out on the equipment must be performed by skilled, qualified technicians.
DANGER!
Failure to observe safety standards could result in fatal accidents or serious injury, and damage
equipment or the environment.
CAUTION!
If the unit is found to be damaged externally or internally, or any of the accessories are damaged or
missing, contact SOCOMEC. Do not operate the unit if it has suffered a violent mechanical shock
of any kind.
NOTE!
Install the unit in accordance with clearances in order to prevent access to handling devices and
guarantee sufficient ventilation (refer to 'Environmental requirements' chapter).
NOTE!
Only use accessories recommended or sold by the manufacturer.
NOTE!
When the equipment is transferred from a cold to a warm place wait approx. two hours before
putting the unit into operation.
Avoid exposing the UPS to contact with water or any liquids generally. Do not insert foreign objects
into the cabinet.
WARNING!
Connect the protective earth (PE) conductor before making any other connections.
The wiring methods in accordance with the National Electrical Code, ANSI/NFPA 70 and Canadian
Electric Code (CEC) are to be used.
All national standards applicable to batteries must be observed.
CAUTION!
To reduce the risk of fire, connect only to a circuit provided with 200 amperes maximum branch-
circuit overcurrent protection in accordance with the National Electrical Code, ANSI/NFPA 70.
DANGER! RISK OF ELECTRIC SHOCK!
Before carrying out any operations on the unit (cleaning and maintenance performances, connec-
tion of appliances, etc.) disconnect all power sources.
DANGER! RISK OF ELECTRIC SHOCK!
After disconnecting all power sources wait approx. 5 minutes for the complete discharge of the
unit.
NOTE!
Any use other than the specified purpose will be considered improper. The manufacturer/supplier
shall not be held responsible for damage resulting from this. Risk and responsibility lies with the
system manager.
• Use the UPS in accordance with the technical specifications indicated in this manual (chapter 'Operating modes').
• A specific input with remote EPO (Emergency Power Off) is available.
• In the event that the equipment has no automatic backfeed protection contactor device, make certain that:
- the user/installer attaches warning labels to all mains isolating switches located remotely from the area where the
UPS is sited, in order to inform service personnel that the circuit is connected to a UPS.
- an external isolating device is installed.