CHAPTER 1: INTRODUCTION
7
Status Indicator LED
LED LED
Behavior
Meaning
1 blink per second
Bluetooth
radio is on, but not
connected
Bluetooth
Status (Blue)
1 blink per 3 seconds Scanner connected to computer
Good Read (Green)
On
Data successfully scanned and
transmitted to host device
On when connected
to charging source
Scanner is fully charged
1 blink per second
20% battery capacity remaining
On when connected
to charging source
Battery Charging (on cradle or
AC power)
Battery Status (Red)
Off
Powered off or Good Battery
status
Status Indicator Beeps
Beep Patterns
Meaning
2 beeps (low-high)
Power on
2 beeps (high-low)
Power off
1 beep
Scanner connected to computer. When connected, the
scanner will auto power off after 2 hours of inactivity.
2 beeps (same tone)
Scanner disconnected from computer. When
disconnected, the scanner will auto power off after 5
minutes of inactivity.
2 long beeps (same tone)
Scanner unsuccessfully tried 10 times to connect to
computer. After these attempts, the scanner will go
into sleep mode and power off after 5 minutes of
inactivity.
1 beep with green LED
Data successfully scanned and sent to computer.
5 consecutive tones
The scanner detects an internal fault and will reset
itself. If the scanner is connected to a host computer,
it will disconnect during the reset.
