7
4. Connect the high-pressure hose to the trigger gun. Push
until the hose snaps into place (Fig. 4). To release the
high-pressure hose from the trigger gun, press the release
button and pull the hose out.
5. Connect the other end of high-pressure hose to the water
outlet of the pressure washer. Push until the hose snaps
into place (Fig. 5). To release the high-pressure hose from
the pressure washer, push the release switch and pull the
hose out.
m
WARNING!
Keep hose away from sharp objects.
Bursting hoses may cause injury. Examine hoses regularly and
replace if damaged. Do not attempt to mend a damaged hose.
6. Connect the garden hose adapter (female coupler) to the
water inlet of the pressure washer
, then thread your
garden hose (male end) into the garden hose adapter
(Fig. 6). The garden hose must have an internal diameter
of at least 13 mm (1/2 in.) and must be reinforced. The
water supply flow rate must be at least equal to the
pressure washer’s delivery capacity.
Fig. 4
Trigger gun
High-pressure hose
Release button
Fig. 5
High-
pressure
hose
Water outlet
.
Release switch
7. Attach garden hose to water supply (Fig. 7).
Fig. 7
Garden hose
Connect
to water
supply
m
WARNING!
Do not connect to potable water system.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
100 PSI.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
Operation
Using the Pressure Washer
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
Fig. 6
Garden
hose
Water
inlet
Garden
hose
adapter
