SNOWJOE sunjoe 24V-WB1000, Руководство оператора

Страница: 12 / 68

12
Rear Wheel Frame Assembly
1. Insert the rear wheel frame into the base frame as shown
below (Fig. 10).
NOTE: The height of the rear wheel frame can be adjusted
in 3 levels by aligning the hole on the base frame with
one of the 3 holes on the rear wheel frame. Insert the
remaining 2 sets of handle knob with short bolt in the
aligned holes of the rear wheel frame and the base frame
as shown (Fig. 10).
NOTE: When using the wheelbarrow on slope, it's
recommended to assemble the rear wheel frame by the
lower 2 holes, so the middle terrain wheel will always be
on the ground.
2. Secure the assembly by turning the hand knobs clockwise
firmly (Fig. 11).
Fig. 9
Cable clips
Cable clips
Fig. 10
Rear wheel
frame
Hand knobs
with short
bolts
LED Headlights Assembly
1. Place one of the light assemblies on the inside of the base
frame, as shown. Align the biggest hole with the hole of
the base frame (Fig. 12).
2. Secure the LED light assembly with a set of M6x16 screw
+ flat spring washer. Use the hex wrench to turn
the screw clockwise tightly (Fig. 13).
3. Repeat the above steps to assemble the other LED
headlight.
Fig. 11
Rear wheel
frame
Tighten
the knobs
Fig. 12
LED headlight
assembly
Align the holes
Fig. 13
LED headlight
assembly
M6x16 screw
Hex wrench
Spring washer
Flat washer