13
5. Reinstall the spool back to the spool hub. Push down until
the spool releasing tabs click into the slots (Fig. 20).
IMPORTANT:
Only use original replacement parts specified for
this machine.
You can purchase a replacement pre-wound spool (Model
24V-ST14B-SPOOL) and other genuine replacement parts
by visiting us online at sunjoe.com or calling our toll-free
customer service helpline at 1-866-SNOWJOE (1-866-766-
9563). The use of parts that do not meet the original equipment
specifications may lead to improper performance of the grass
trimmer, may compromise operator safety and will void the
manufacturer's warranty.
Winding the Line
NOTE: Should you wish to wind the line yourself, the
instructions are provided below. Self-winding, however, is NOT
recommended because if the line is not wound properly it can
cause the trimmer’s bump feed system to malfunction. For this
reason, users are strongly urged to purchase the pre-wound
spool.
1.
Turn off and remove the battery. Make sure the spool has
come to a complete stop.
2. To remove the spool from the trimmer hub, follow steps
1 and 2 from the section "Replacing the Spool + Clearing
Jams and Tangled Lines" beginning on page 12.
3.
Find the middle of a new piece of cutting line and insert
the middle of the line into the groove in the center of the
spool (Fig. 21).
4. Wind both ends into the grooves using slight tension and
following the direction of the arrows (Fig. 22).
5. Re-install the spool as instructed in steps 3 to 5 of
"Replacing the Spool + Clearing Jams and Tangled Lines".
m
CAUTION!
Catapulted pieces of nylon line may cause
injury.
m
WARNING!
Pay attention to the winding direction.
NOTE: Always replace the spool with a new pre-wound spool.
Visit sunjoe.com to purchase the pre-wound spool (model
24V-ST14B-SPOOL) for this cordless grass trimmer.
Fig. 20
Spool
Slot
Spool hub
Spool
releasing tab
(on both
sides)
Fig. 21
Groove
Fig. 22
