SNOWJOE iON8024-CT-RM, Руководство оператора

Страница: 10 / 26

9
Discharge Chute Assembly
1. Use the hex key to remove the 4 nuts from the gear plate.
Keep them on the side (Fig. 3).
2. Place the discharge chute assembly onto the gear plate,
aligning the 4 holes in the gear plate, and push down until
the chute is flush and flat against the housing (Fig. 4).
3. Using the 4 nuts, secure the discharge chute assembly to
the gear plate (Fig. 4).
4. Press the chute deflector trigger to raise or lower the
chute deflector to the desired height of the snow stream
(Fig. 5).
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip (Fig. 6).
Skid Shoes Adjustment
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces.
The snow blower skid shoes are adjusted at the factory for
shipping purposes. Adjust them downward, if desired, prior to
operating the snow blower.
m
WARNING!
It is not recommended that you operate this
snow blower on gravel as it can easily pick up and throw loose
gravel, causing personal injury or damage to the snow blower
and surrounding property.
1. For close snow removal on a smooth surface, raise skid
shoes higher on the auger housing. Allow 1/8 in. (3 mm)
between scraper blade and hard, smooth surface(s).
2. Use a middle or lower position when the area to be
cleared is uneven, such as a gravel driveway. Allow
1-1/4 in. (30 mm) between scraper blade and uneven or
gravel surfaces.
NOTE: If you choose to operate the snow blower on a
gravel surface, keep the skid shoes in position for maximum
clearance between the ground and the scraper blade.
To adjust the skid shoes:
3. Loosen the 4 hex nuts (2 on each side). Move skid shoes
to desired position (Fig. 7).
Fig. 3
Nut
Hex key
Gear plate
Fig. 4
Nuts
Gear plate
Discharge chute
assembly
Fig. 5
Chute
deflector
trigger
Fig. 6
Chute clean-out tool
Fig. 7
Skid shoe
Hex nut