SNOWJOE iON100V-21SB-CT-RM, Руководство оператора

Страница: 13 / 24

13
2. Rotate the handle frame up in a comfortable operation
position (Fig. 9).
3. Lock the handle frame in position by rotating the handle
frame locks on both sides counter-clockwise (Fig. 10).
Discharge Chute Assembly
1. Place the discharge chute assembly onto the gear plate,
aligning the 3 holes in the gear plate, and push down until
the chute is flush and flat against the housing (Fig. 11).
2. Use the 3 discharge chute screws to secure the discharge
chute assembly to the gear plate as shown. Tighten with
the provided hex key (Fig. 12 ).
Operations
m
WARNING!
AVOID INJURY. Read and understand the
entire safety section before proceeding.
NOTE:
Before inserting the battery pack(s), verify that the snow
blower’s auger and rubber plates are firmly secured. Perform a
test run to ensure that the rotor turns freely.
St Stopping
m
WARNING!
The auger starts rotating immediately after
the snow blower is switched on. Keep hands and feet away
from the auger.
1. Open the battery compartment cover and then push the
battery pack(s) down until it clicks and locks into position
(Fig. 13). Either side of the battery compartments may be
used. Close the cover.
Fig. 8
Handle frame
Handle frame
lock
Fig. 9
Handle frame
Fig. 10
Handle frame
Rotate to
lock
Fig. 11
Discharge
chute assembly
Gear
plate
Fig. 12
Screws
Gear plate
Discharge chute
assembly